Watson-Marlow 520Du User Manual
Page 38
Watson-Marlow 520Du User Manual
38
Program
Select Program using the UP or DOWN keys and press ENTER to confirm.
The pump offers two choices: mA and V. Use the UP or DOWN keys to make
a selection and press ENTER to confirm your decision.
The pump displays a screen allowing you to set the speed for low signal input.
Use the UP and DOWN keys to scroll the display to your chosen speed and
press ENTER to confirm the figure.
The pump displays a screen allowing you to set the speed for high signal input.
Use the UP and DOWN keys to scroll the display to your chosen speed and
press ENTER to confirm the figure.
If a mistake is made, the user may press STOP at any point in the sequence
(before pressing ENTER on the high signal speed screen), and the pump dis-
plays the previous screen.
The final press on ENTER causes the pump to configure the hardware and pro-
grammed response data. It briefly displays a confirmation screen and a warning
that the analogue signal is not trimmed, and returns the user to the Analogue
setup menu. Example values are shown here.