beautypg.com

Vuzix Wrap 1200DXAR User Manual

Page 19

background image

19

bridge assembly’s stem in or out of the display module you can adjust the resting
height of the displays. By bending the wire nose pad arms you can address the angle
and spread of the pad to achieve optimum comfort.

To adjust the nose bridge:

§

Slide the nose bridge assembly in and out to adjust its reach to position the

eyewear displays directly in your line of sight.

If you pull the nose bridge assembly too far out it will come completely out of the
display module. Don't worry if this happens as it can be easily slid back in and
enables you to replace the nose bridge assembly should it be broken.

§

Gently bend the wire arms of the nose pad to achieve a comfortable fit with the

pad’s face resting on the bridge of your nose – in the same manner that you
would adjust the nose pads on standard eyeglasses.

Gentle persuasion with a pair of needle nose pliers works best to bend the wire nose
pad arms. This places the least amount of strain on the assembly and adjacent parts.
The wire nose pad arms are not designed for frequent bending or sharp angles as this
may weaken and break them. Replacement nose pad assemblies are available for
purchase from Vuzix (

www.vuzix.com

).

IPD (InterPupillary Distance) is the distance separating your eyes - sometimes
referred to simplify as “eye-separation”. IPD varies from one person to the next and
when yours does not match close enough to the eyewear displays, the image in one
eye or the other may darken or disappear entirely.

Each display adjusts independently by sliding it left or right.

To adjust the IPD:

§

Close one eye and slide the display box for the other eye left or right to provide

the clearest and brightest image.