Vuzix Wrap 1200DXAR User Manual
Page 18
18
remain on and the blue illumination will flash indicating that the device is on and
charging.
The Wrap 1200DXAR provides two independent VGA (640x480) cameras with
natural eye separation to provide realistic stereoscopic 3D image capture. The
cameras provide full-frame, sub-sampled or windowed 8-bit images in a wide range
of formats, controlled through the Serial Camera Control Bus (SCCB) interface.
Each camera has an image array capable of operating at up to 30 frames per second
(fps) in VGA with complete user control over image quality, formatting and output
data transfer. All required image processing functions, including exposure control,
gamma, white balance, color saturation, hue control and more are programmable
through the SCCB interface.
Active Array Size
640 x 480
Temp. Range (stable image)
0°C to 70°C
Output Formats (8-bit)
YUV/YCbCr 4:2:2
RGB565/555/444
GRB 4:2:2
Raw RGB Data
Max Image Transfer Rate
30 fps for VGA
Sensitivity
1.3 V/(Luxsec)
S/N Ratio
46 bB
Dynamic Range
52 dB
Scan Mode
Progressive
Electronics Exposure
Up to 510:1 (for selected fps)
Pixel Size
3.6 µm x 3.6 µm
The USB controllers in some PCs have difficulty satisfying the bandwidth
requirements of two cameras.
• If your cameras are connected through a USB hub or use a USB extension cable,
try connecting the cameras directly to a USB port on your computer.
• If you encounter this issue, try using a different USB port, such as a USB 3.0
port, as it may use a different controller or try using it on a different computer.
• If the above fail to resolve the issue, lower the bandwidth requirement by
reducing the frame rate to 15 fps.
The WRAP 1200DX’s nose bridge and pads are adjustable. For the best viewing
experience your displays should be centered in front of your eyes. By sliding the nose
“AMCap” is a Windows
application installed with
the Wrap 1200DXAR for
verification of proper
camera operation.