Vuzix Wrap 1200DXAR - Manual (Page 17)

17
Most HDMI devices do not require display configuration adjustment when
connected to a Wrap 1200DXAR. Some computer systems may require adjustments
to their display settings to enable the Wrap 1200DXAR as second or external
display.
The computer must be configured to support the Wrap 1200DXAR as an external
monitor, duplication its desktop or laptop monitor. Depending upon your
operating system this configuration may be referred to as duplicate, mirrored, or
clone display mode.
If the display settings do not automatically adjust to a resolution commonly
supported by the desktop and eyewear monitors, it must be manually set to one of
the following resolutions:
• 1152 x 648
• 1280 x 720
• 1600 x 900
• 1920 x 1080
2D and 3D video is supported on all known makes and models of Windows
compatible graphics cards. No additional 3D drivers are required.
3D Video
By default the eyewear supports standard 2D video. Stereoscopic 3D video support
is provided for side-by-side, top/bottom and frame packed content. A compliant
HDMI 3D capable source will automatically configure the eyewear for the correct
3D mode and enable 3D display. You will not be able to change the 3D settings of
the eyewear when it is automatically configured in this manner.
Battery
The Controller contains a rechargeable lithium ion battery, recharged by connecting
it to a USB charger (wall outlet or computer port) with an output of 1 amp or
greater.
Recharging a fully depleted battery can take up to 8 hours.
The Vuzix icon on the Controller will illuminate red while the device is plugged
into the charger. If the device is plugged in and turned on, the red illumination will
Video content must be
displayed “full screen” on
a PC to be viewed in 3D.
Other resolutions may be
available on your
computer system but may
not display in the proper
aspect ratio. For best
results, use one of these
supported resolutions.