Denon S-102 - Manual (Page 14)

0
Set
up
Pla
ybac
k
Remot
e Contr
ol
Inf
or
mation
Tr
oubleshooting
ENGLISH
-
7*%&0
*/
3
Sy
stem cable
Speaker cable
Speaker cable
White Red
White
Red
ADV-S102
DSW-S102 SC-S102
TV
The set includes
a built-in clock
function. Connect
the set’s power
cord to a wall
power outlet to
which power is
always supplied.
Power cord
To household
power outlet
(AC 120 V, 60 Hz)
Video cable
NOTE
• Connect the set’s video output directly to the TV. Do not connect it via a VCR (video cassette recorder).
Some discs contain copy prohibit signals, and the picture could be disturbed if such discs are played via
a VCR.
• Insert the plugs securely. Incomplete connections will result in the generation of noise.
• Do not unplug the power cord while the set is operating.
• When connecting system cables and speaker cables, first lay them out sideways. When laying them out
take care not to damage them.
Connecting the System
A home theater can be achieved easily using the included cables to connect the DVD surround receiver
(ADV-S102), subwoofer (DSW-S102), speakers (SC-S102) and your TV set.
Get
ting Star
ted
Connections
Protector circuit
The protection circuit will be activated in the
following cases:
• When the speaker output is short-circuited
• When the temperature around the set is
extremely high
• When the set is used for long periods of time
with a high output and the internal temperature
rises
When the protection circuit is activated, the
speaker output is cut off and the power supply
indicator flashes. Should this occur, please follow
these steps: be sure to switch off the power of
this unit, check whether there are any faults with
the wiring of the speaker cables or input cables,
and wait for the unit to cool down if it is very hot.
Improve the ventilation condition around the unit
and switch the power back on.
If the protection circuit is activated again even
though there are no problems with the wiring
or the ventilation around the unit, switch off the
power and contact a DENON service center.
Mounting the speaker stand and bracket
b Be sure to tighten the screws completely.
b Also be careful when installing.
Wall
Screws
(included)
Speaker Stand
(included)
Stick the cushion pad here. (Included)
b When placing the speaker system (SC-S102) on a
stand, etc., stick the included cushion pads at the
two corners of the bottom surface.
(Refer to the illustration above.)
Note on speaker impedance
If speakers with an impedance below the specified
impedance (4 Ω/ohms) are used (for example,
speakers with an impedance of 3 Ω/ohms) with
the volume turned up high for long periods of
time, the temperature may rise, activating the
protective circuit.
When the protection circuit is activated, the output
to the speakers is cut off and the power indicator
blinks. If this happens, unplug the power supply
cord, wait for the set to cool off and improve
ventilation around the unit. Also check the wiring
of the input cables and the speaker cables. After
doing this, plug the power supply cord back in and
turn the unit’s power back on.
If the protection circuit is activated again even
though there are no problems with the wiring
or the ventilation around the unit, switch off the
power and contact a DENON service center.