Verilink WANsuite 5165 (34-00301.H) Product Manual - Manual (Page 93)

W e b S e r v e r I n t e r f a c e 3-63
The Static Route Table (Figure 3.54) is always associated with a circuit.
Access this screen by selecting the Static Route Table from the RIP
Parameters Table on the IP Gateway Details screen.
Figure 3.54 Static Route Table Screen
Endpoint Endpoint name (or interface) through which to send the IP packet to reach the
Target IP Address.
Target IP Address Represents the target network that you want this router to reach.
Target IP Mask Mask of the Target network.
Next Hop IP address of the next device in the route.
Cost Cost of using that route.
Route Status Indicates whether a route is enabled or disabled.
The Static Route Table screen provides the following user-activated buttons:
Route Details Screen
Access this menu (Figure 3.55) by clicking on the appropriate numbered link
under the “Index” column on the Static Route Table screen.
Button Function
Dynamic Route Table Displays all known routes.
Add New Adds a new static route.