Verilink WANsuite 5165 (34-00301.H) Product Manual - Manual (Page 177)

V T 1 0 0 I n t e r f a c e 4-53
Diagnostics Screen
The Diagnostics screen (Figure 4.45) provides a table for viewing the current
settings for the test and maintenance functions performed on the available
interfaces. This screen shows an upper-level view of all the interfaces so you
can see if any port is under test, and if so, view the results. You may change
Diagnostic parameters on the Test Details screens, which are accessed by
selecting the appropriate interface under the column.
Figure 4.45 Diagnostics Screen
Description Describes the type of interface selected for testing.
Loop Type Describes the type of loop test (if any) performed on the selected interface.
Setting Displays the bandwidth on which you wish to perform the BERT.
Pattern Specifies the pattern to be transmitted during a BERT for the selected port.
Length Displays the length of time for which the BERT should run for the selected
interface.
State Displays the current BERT state for the selected interface.
Test Details Screens
The Test Details screens let you set some test parameters and view other read-
only parameters. These screens are also used to initiate a BERTs or Loop
Tests. The Network Interface Test Details screen is shown in Figure 4.46, and
its parameters are described below the figure. The Serial Interface Test Details
screen is shown in Figure 4.47, followed by a description of its parameters.