Verilink WANsuite 5165 (34-00301.H) Product Manual - Manual (Page 123)

W e b S e r v e r I n t e r f a c e 3-93
the local router (Router A) for each remote WANsuite 5165 to manage. If
Router A becomes unavailable, there is no way to reach the remote
WANsuite 5165s.
Use of Local WANsuite 5165 as a Gateway
If you choose this method, the WANsuite 5165s are totally independent from
the routers, so all units will be accessible as long as the frame relay network
stays up. The IP address assignment is also independent from the routers. The
PC used for management must have the local WANsuite 5165’s IP address as
its gateway address so that it can reach all remote WANsuite 5165s.
Figure 3.96 Frame Relay Network
In the local WANsuite 5165, the IP address and mask of each remote
WANsuite 5165 will have to be configured in the Endpoint table. The “In-
Band Management” parameter will also have to be set in the corresponding
DLCI. Each remote WANsuite 5165 must be part of a different IP network
address.
PC
Router
A
FSM
FSM
FSM
Router
C
Router
B
WAN SUITE
5165
WAN SUITE
5165
WAN SUITE
5165