Verilink WANsuite 5165 (34-00301.H) Product Manual - Manual (Page 48)

3-18 W A N s u i t e 5 1 6 5
Parity Sets the parity bit.
Values: None, Odd, Even
Default: None
Stop Bit Selects the number of bits required to end the character.
Values: 1, 2
Default: 1
Current Pin Status Shows the status of the DTE Supervisory port pins.
DTR Alarm Control and Status Table
In addition to the configurable fields, the Supervisory screen displays a table
that lets you set the Data Terminal Ready (DTR) Alarm Control parameters
and view the current DTR Alarm Status.
Choices for DTR Alarm Control are “Enable” and “Disable”; the default
setting is “Disable.” Setting DTR Alarm Control to “Enable” allows the unit
to go into alarm on a loss of DTR, which occurs when the Serial port detects
that the DTR signal is low. The DTR Status field indicates the current state of
the DTR alarm.
Services Screen
The Services screen (Figure 3.15) displays the unit’s defined services and the
Interface, Type, and Pair, and Status parameters for each service.
Figure 3.15 Services Screen
The Status for a particular service will display as one of the following:
• Dead
−
The service is not functional because required resources are not
available.
•
Changed
−
The service parameter was changed and a Save and Restart is
required for the service to function.
•
Down
−
The service is not able to pass data because the physical layer is
down.
• Physical Up
−
The service is not able to pass data because it has not
completed any required negotiations.