Verilink WANsuite 5165 (34-00301.H) Product Manual - Manual (Page 188)

4-64 W A N s u i t e 5 1 6 5
Endpoint Endpoint name (or interface) through which to send the IP packet to reach the
Target IP Address.
Target IP Address Represents the target network that you want this router to reach.
Target IP Mask Mask of the Target IP or network.
Next Hop IP Address: IP address of the next device in the route.
NOTICE: Setting the Target IP Address and Target IP Mask to 0.0.0.0 defines
THE default route for this unit.
Cost Cost of using that route.
Route Status Indicates whether this route is enabled or disabled.
Dynamic Route Table Screen
Access this menu by selecting the “Static Route Table” on the IP Gateway
menu and then selecting Dynamic Route Table. This table shows all known
dynamic and static routes. Please note that not all parameters are necessarily
defined, depending on whether or not the routes were learned dynamically.
Primarily, the most useful information is included in "Destination," "If Ndx,"
and "Mask" columns.
Figure 4.55 Dynamic Route Table Screen
The Dynamic Route Table displays the fields listed below.
Field Description
Destination Network to be reached.
If Ndx Internal TCP/IP stack interface number.
Next Hop IP address used to reach the destination network.
Mask Mask of the destination network.