Verilink PRISM 3002 (34-00277) Product Manual - Manual (Page 44)

4-22 T ERMINAL C ONFIGURATION AND T ESTING
Dial String
This is the character string used to dial the other unit.
Init String
This is the character string used to configure the modem to dial the other unit.
Reset String
These strings (1 through 5) are used to reconfigure the ISDN TA when the unit has
trouble making a connection.
Configure ISDN TA
Routes the user interface of the switched service DBU unit. This feature allows for
the configuration of necessary parameters in the switched unit.
Activation Periods
Then period when the unit is allowed to enter an active DBU state.
When configuring activation periods in the Time of Day map, remember to calculate
any time zone differences.
Management
Ports
The Management Ports screen (Figure 4-11) sets the following parameters for the
Call On Alarm (COA) connection on both the SUPV and SLIP ports.
Element ID
This field allows the entry of an ASCII string (up to 29 characters) which
identifies the unit to the device receiving the alarm notification messages.
Call on alarm messages are reported in the following format in the DIAL or
DIRECT modes only:
Figure 4-11 Management Ports Screen
3002 DSU 1.00/2.40 3 0 0 2 Date: 06/24/97
No Far End Response Time: 08:43:13
------------------------------- Management Ports -------------------------------
Element ID: ( )
------------------------------- Supervisory Port -------------------------------
COA Connection: (DISABLED)
Primary Dial String: (ATDT )
Secondary Dial String: (ATDT )
Initialization String: (ATEQ0V1 )
Disconnection String: (ATH )
----------------------------------- Messages -----------------------------------
Local Screen