Verilink PRISM 3002 (34-00277) Product Manual - Manual (Page 27)

Alarms Screen 4-5
Alarms Screen The Alarms screen (Figure 4-4) allows viewing the current alarm status of the
network and the DTE lines.
NET Alarms These status lines display the selected element’s current network signal alarm state
(Table 4-2). Alarms are determined by the selectable thresholds in the Alarm
Configuration screen (see Figure 4-8 on page 4-17).
Figure 4-4 Alarms Screen
3002 DSU 1.00/2.40 3 0 0 2 Date: 06/24/97
No Far End Response Time: 08:36:09
------------------------------------ ALARMS ------------------------------------
Element: NEAR]
NET Alarms: NONE
DTE Alarms: NONE
Current Threshold
Loss of Signal Seconds (LOSS): 0 5
Errored Seconds (ES): 0 45
Severely Errored Seconds (SES): 0 5
Unavailable Seconds (UAS): 0 0
Out of Frame Seconds (OOFS): 0 5
Remote Alarm Seconds (RAS): 0 0
AIS Seconds (AISS): 0 0
BPV Seconds (BPVS): 0 0
Power Loss Seconds (PLS): 0
Reset Alarm Registers: (RESET)
----------------------------------- Messages -----------------------------------
Local Screen
Table 4-2 NET Alarm Indicators
Alarm Description
------- No status is available.
OK No alarm threshold has been exceeded, although errors
may exist which do not exceed thresholds.
ERRS The Errored Seconds, Severely Errored Seconds, or
Bipolar Errored Seconds threshold is exceeded.
LOSS The Loss Of Signal Seconds threshold is exceeded.
OOFS The Out Of Frame Seconds threshold is exceeded.
RAIS The Remote Alarm Seconds threshold is exceeded.
AISS The Alarm Indication Seconds threshold is exceeded.
UAS The Unavailable Seconds threshold is exceeded.
DBA Dial Backup Active.
DBF Dial Backup Failed.