Triplett 9055 - Manual (Page 33)

31
Measuring DC Voltage
1.
Insert the black test lead into the COM jack and
red test lead into the “V/Hz%/Ω/Cap/
Temp” jack.
2. Set the Function Switch to the DCV range and connect
the test leads across the source or load under
measurement.
3. Read the DC voltage on the LCD.
4. If the voltage to be measured is less than 400mV, set
the meter to the DCmV range and then read the voltage
on the LCD.
Notes:
Use the RANGE button to manually select the desired DCV
range.
Use the REL button to ‘zero’ a reading.
Use the HOLD button to freeze a reading or turn on the
Backlight.
Measuring AC Voltage
1.
Insert the black test lead into the COM jack and
red test lead into the “V/Hz%/Ω/Cap/
Temp” jack.
2. Set the Function Switch to the ACV range and connect
the test leads across the source or load under
measurement.
3. Read the AC voltage on the LCD.
4. If the voltage to be measured is less than 400mV, use
the RANGE button to manually select the 400mV
range.