Triplett 9055 - Manual (Page 11)

9
2.17 Do not attempt to measure a voltage source with
the test leads plugged into the meter's uAmA or 10A
jacks. Doing so may damage the meter and/or
injure the user.
2.18 Do not rotate the Function switch with the test leads
connected to the circuitry to be tested. Doing so
may damage the meter or the circuitry, and/or injure
the user.
2.19 Replace fuses only with exact or equivalent fuses.
Do not "bridge" fuses out of circuit. Failure to
observe this precaution may result in damage to the
meter or injury to the user.
2.20 Do not apply voltages to the input of the meter
which are elevated above the earth ground
potential by more than 600V CAT IV AC/DC or
1000V CAT III AC/DC. Doing so may damage the
meter and/or injure the user.
2.21 Do not continue to use meter when the "low battery"
symbol is displayed. The displayed reading
may be in error and lead the user to believe that no