Tri Tool 642SB Clamshell Air and Hydraulic - Manual (Page 30)

30
TRI TOOL INC.
92-0612 Rev. 131230
Push Tool Bit A forward until it makes contact with the bottom of the slot.
Do not move Tool Bits D and E.
Rotate the Feed Sprocket for Tool Block No. 2 counter-clockwise to bring Tool Bits
B and C back into contact with the bevel that they have previously cut.
Visually check the Feed Pin to Sprocket engagement for Tool Block No. 2.
Leave Tool Bits D and E in contact with the beveled surface made by Tool Bits B
and C as shown.
Resume the pipe cutting operation.
Go back to “When the machining operation is finished…’.