Tri Tool 642SB Clamshell Air and Hydraulic - Manual (Page 18)

18
TRI TOOL INC.
92-0612 Rev. 131230
NOTE:
LUBRICANT RECOMMENDATIONS
The Drive Gears require a high string lubrication grease such as “Chevron Utility
Grease” (P/N 68-0020).
The Slide Rails and Tool Blocks require a light oil such as SAE 10 light machine oil.
The Feed Screw for the Tool Block and the Tripper Block Assy require a SAE 10 light
machine oil for normal conditions and under dusty conditions a silicone, graphite or
molybdenum disulfide ‘dry’ lubricant.
A light film of all-purpose grease may be used, but it must be checked for
grit contamination frequently.
The bearings in the Drive Motors are sealed and do not require any lubrication.