Tri Tool 576AC Sever Machine with Air Motor - Manual (Page 8)

92-1176 : Orig. 041012
TRI TOOL INC.
8
CAUTION
SELECTION:
INSTALLATION:
Make sure that the Model 576AC is disconnected from its power source
before installing a tool bit.
Install a collet into the Model 576AC.
Insert a tube into the collet and bring it flush to the front of the collet and
clamp the tube in place.
Rotate the cam feed knob counter-clockwise with a 3/8” wrench, so that
the scribe mark points to the bottom (this will place the tool holder to the
end of the feed).
The cam can only rotate in the direction noted on the knob with an
arrow.
Slide a tool bit into the tool slot until the end of the cutting edge of the tool
bit passes the ID of the tube by approximately .020".
DO NOT install the tool bit backwards; it will not cut and may destroy
the tool bit.
Secure the tool bit in place by tightening the (6) six set screws in the tool
holder.
Rotate the cam feed knob until the tool holder returns to top of its travel.
Pipe
Max or
Wall Tube
Range Thk Mat’l Notes:
The following tool bits leave the burr on the piece on which the machine is mounted on:
.016” thru .040” 99-5482 Tool Bit, Sever, Right Hand, .040” wide
.040” thru .065” 99-5477 Tool Bit, Sever, Right Hand, .060” wide
.065” thru .156” 92-5472 Tool Bit, Sever, Right Hand, .100” wide
The following tool bits leave the burr on the piece opposite to which the machine is mounted on:
.016” thru .040” 99-5481 Tool Bit, Sever, Right Hand, .040” wide
.040” thru .065” 99-5480 Tool Bit, Sever, Right Hand, .060” wide
.065” thru .156” 99-5473 Tool Bit, Sever, Right Hand, .100” wide
WARNING
NOTE
TOOL BITS