Tri Tool 576AC Sever Machine with Air Motor - Manual (Page 16)

92-1176 : Orig. 041012
TRI TOOL INC.
1 6
PROBLEM: The pipe or tube is slipping in the collet.
The clamping pressure is not tight enough.
Scale and/or other foreign material is present on the pipe or tube.
Weld seams, swelling, or bumps are preventing full contact of the collet.
Dull tool bits are causing extra force in the axial and/or radial direction.
PROBLEM: The tool bit will not reach the work.
An incorrect tool bit is installed.
PROBLEM: The air motor will not start.
The air supply is shut off.
The air motor will not run free. The air motor may need lubrication. Add
lubrication to the air motor and wait a few minutes before attempting to run
it again. Try running the motor again. If it still will not run, the vanes may
be sticking; tap on the air motor casing lightly with a piece of wood or with
a soft rubber mallet.
Sand or other foreign material is in the vanes of the air motor.