Tri Tool 576AC Sever Machine with Air Motor - Manual (Page 11)

1 1 92-1176 : Orig. 041012
576AC SEVERMASTER TM with Air Motor
Tripper Shaft
Handle
Mount tool holder #1 for tube ranging from 4.50” to 6.625” (114.3 mm to
168.3 mm).
Mount tool holder #2 for tube ranging from 2.00” to 4.50” (50.8 mm to
114.3 mm).
MACHINING INSTRUCTIONS:
Turn the motor on to full speed by depressing the lever.
Engage the feed by pushing the tripper shaft in.
Monitor the cutting operation and apply cutting fluid as necessary.
The machine operation is finished when the tool holder returns home,
release the lever in order to turn off the motor.
Loosen the collet by rotating the handle up.
Remove the pipe or tubing from the Model 576AC.
The tool holder will retract automatically in 5 to 10 revolutions.
There is an audible ‘snap’ when the tool holder returns to the home
position.
Observe the relationship between the pipe or tube and the tool bit.
The tool holder may be reset quickly by hand by rotating the cam feed
knob to pick up the feed slack.
It is not necessary to disengage the tripper shaft after each cutting
operation.
NOTE
NOTE
Cam feed knob