Tri Tool 230B Miter Mandrel - Manual (Page 20)

20
TRI TOOL INC.
92-0841 : Rev. 050317
Problem: There is a loss of air power
The air supply pressure is too low.
The air filter is plugged.
The air line size is insufficient.
The air line is too long.
Problem: There is a loss of hydraulic power
The hydraulic supply pressure is too low.
The hydraulic filter is plugged.
The hydraulic line size is insufficient.
The hydraulic line is too long.
Problem: The air motor will not start
The air power supply is shut off.
The air motor is damaged and will not run free. The air motor needs lubrica-
tion.
Add lubrication and do not run the air motor for a few minutes, then try run-
ning the motor. Tap on the side of the air motor casing lightly with a piece of
wood or with a soft rubber mallet just in case the vanes may be sticking.
Problem: The hydraulic motor will not start
The hydraulic power supply is shut off.
The hydraulic motor is damaged and will not run free.
TROUBLE SHOOTING