Tri Tool 230B Miter Mandrel - Manual (Page 19)

19
Model 230B Miter Mandrel
92-0841 : Rev. 050317
DISASSEMBLY AND ASSEMBLY
Back off the four (4) Parallel Offset Adjusting Screws about three full turns each.
Unscrew the Draw Rod and slide the Mandrel Shaft Assembly rearward.
Remove the Draw Nut, the Adapter Plate Assembly and the Torque Plate.
Remove the four (4) Angular Offset Adjustment Screws and the four (4) Spherical
Bearings.
Remove the Gimbal Plate.
Remove the Jackscrews and Spacers from the Head Assembly.
Assembly is done in reverse order of disassembly.