Tri Tool 230B Miter Mandrel - Manual (Page 15)

15
Model 230B Miter Mandrel
92-0841 : Rev. 050317
NOTE:
It is highly desirable to mount the Miter Head so that the Angular Offset Pivot
point is on the same plane with the proposed finished wall preparation.
This will diminish the amount of parallel offset required after the angular adjustment
has been made.
Using a tape measure or steel rule, keep the rear flange of the Gimbal Plate roughly
centered while turning the Jackscrews to tighten them against the ID of the
workpiece.
Use the wrenches provided to tighten all eight (8) Jackscrews securely.
Mount the Indicator Sleeve to the Adapter Plate Assembly and tighten the Mounting
Nut.
Final Face Line
Workpiece
Dial Indicator Kit
Indicator Sleeve Assembly
Dial Indicator Kit Setup