Tri Tool 230B Miter Mandrel - Manual (Page 17)

17
Model 230B Miter Mandrel
92-0841 : Rev. 050317
many times as necessary to achieve the accuracy desired.
Once the accuracy requirements have been satisfied, evenly tighten all four (4)
Parallel Offset Adjustment Screws.
Recheck the adjustment with the indicator sleeve.
Remove the indicator items and the Indicator Sleeve from the Miter Head.
Tighten the Draw Nut securely.
Torque should be 100 ft/lbs (136 Nm) to 130 ft/lbs (229 Nm).
Align the torque pin holes in the end of the Mandrel Shaft with the torque pins in the
Adapter Plate Assembly.
Install the Mandrel Shaft Assembly onto the Adapter Plate Assembly and tighten the
Draw Rod to 250 ft/lbs (339 Nm) to 300 ft/lbs (407 Nm).
At this time, the Miter Mandrel should feel absolutely tight and rigid.
Before installing the 230B BEVELMASTER™ be sure to read the Operator’s manual
carefully, giving special attention to all safety cautions and warnings.