Tri Tool 224B Single Point - Manual (Page 9)

9 92-0833 : Orig. 990603
Model 224B Single Point
NOTE:
OPERATION
Read the operating instructions carefully before attempting to operate the
Model 224B SP.
Use eye protection at all times when operating the Model 224B SP.
Configure the machine for the proper mounting diameter. (Refer to the Model
224B Operator’s manual)
Attach the Model 224B SP to the Model 224B. (Refer to Installation section.)
Install the mandrel inside the pipe and tighten the draw nut to force the jaw
blocks out against the inside diameter of the pipe.
In order to avoid cutting the jaw blocks during the machining operation, the
mandrel must be installed beyond the final end preparation location.
Tool Bit Clearance
Final Prep Location
Clearance
Set Screw
(Feed Lock)
Feed Handle
Plate
Pipe
Jaw Block
Mandrel Head