Tri Tool 224B Single Point - Manual (Page 12)

92-0833 : Orig. 990603
TRI TOOL INC.
12
Adjustment of the Feed:
Setting Feed Direction:
Lock the tool holder into position with the set screws on the side of the tool
holder.
Put the gearbox into neutral.
Select the proper hole location on the position index plate and the actuator
arm for the required feed.
Set the feed direction by pulling out the knob (for feeding toward the mandrel),
in the center position (for neutral or no feed) or by pushing in the knob (for
feeding away from the mandrel).
Actuator Arm
Feed Out
Neutral
Feed In
Feed Knob
3
1
4
2
Index Plate
B
A
Feed System Set-up
Counterboring Function:
Lock the tool slide in the flat position.
Replace the tool holder and the Insert with the counterbore tool bit.
Insure that the cutting edge is facing out from the center.
Set the feed direction to neutral by moving the feed knob to the center posi-
tion.