Tri Tool 224B Single Point - Manual (Page 14)

92-0833 : Orig. 990603
TRI TOOL INC.
14
Let the machine rotate very slowly for one revolution to verify that the tool bit
clears the ID of the pipe.
Adjust the tool bit into the cutting position, use the manual feed knob on the
tool slide.
Tighten the dovetail slide lock screw in the tool block when desired tool bit
position has been achieved.
This screw must be loosened and re-tightened whenever the dovetail slide
requires repositioning.
If it is not securely tightened, the tool bit may walk out of the cut.
Plunge cut to desired depth.