Transferring a configuration to a device, 7 transferring a configuration to a device – DHD Power Cruiser MADI 52/XR User Manual

Page 33

Series 52 - 52/XR MADI Router Manual

Specifications and design are subject to change without notice. The content of this document is for information only. The information presented in this document does not form part
of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. No liability will be accepted by the publisher for any consequence of its use.
Publication thereof does neither convey nor imply any license under patent rights or other industrial or intellectual property rights.

The synchronisation tab can be seen by selecting the Audio branch.

If a BNC is chosen as sync source, you can define whether the system should react on the rising or the falling edge and
you can activate the input termination if the sync signal ends at this input (no t-piece at the input). As long as BNC 2 is not
selected as a sync source, it is possible to configure it as output. In the output mode you can choose between rising and
falling edge to produce a phase shift.

7.1.7

Transferring a Configuration to a Device

If you want to transfer a configuration to a device, please follow these steps:

Select the desired device in the projects device tree.

Click on the

symbol in the toolbar or choose Load to Device in the Transfer menu. The DHD Connection

Dialog

appears.

Select the desired hardware from the list and press OK.

The transfer process starts and the configuration is copied to the chosen hardware.