Linked 52/mb at a madi port, 5 linked 52/mb at a madi port – DHD Power Cruiser MADI 52/XR User Manual
Page 31
© 2010 DHD Deubner Hoffmann Digital GmbH
28
Series 52 - 52/XR MADI Router Manual
Specifications and design are subject to change without notice. The content of this document is for information only. The information presented in this document does not form part
of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. No liability will be accepted by the publisher for any consequence of its use.
Publication thereof does neither convey nor imply any license under patent rights or other industrial or intellectual property rights.
7.1.5
Linked 52/MB at a MADI Port
If a MADI port was linked to an 52/MB MADI Breakout System, you are able to define the layout of the connected 52/MB
device here. Basically, this part of the configuration is to make the whole configuration process easier. The 52/MB
hardware itself must not be configured.
I/O configuration of a linked 52/MB.
The following modules can be configured in an 52/MB frame:
Slots 1 to 14:
·
52-5111 XLR Digital In/Out Module, 4ch.
·
52-5112 XLR Digital In/Out Module, 4ch.
·
52-5170 (4in/4out or 8in or 8out) HD-SDI Audio Module
·
52-5210 XLR Analog In Module, 4ch.
·
52-5213 XLR Analog In Module, 4ch.
·
52-5220 XLR Analog Out Module, 4ch.
·
52-5223 XLR Analog Out Module, 4ch.
·
52-5230 XLR and Combined XLR/Jack Socket Analog In/Out Module, 2ch.
·
52-5240 XLR Analog In/Out Module, 4ch.
·
52-5243 XLR Analog In/Out Module, 4ch.
·
52-5250 XLR 4 Mic/Line Module, isolated
·
52-5260 XLR 4 Line Out Module, isolated
Slots C1 to C5:
·
52-5310 SubD GPIO Module, 8 out, 4 in
·
52-5311 SubD GPIO Module, 8 out, 4 in
The channels of the selected I/O modules can be configured to mono or stereo and you can set a label for each single
input and output here. Additionally, you can set a local level adjustment for each single input and output.
Moreover, you can adjust the headroom for the inputs of the 52-5230 and 52-5250 modules. Please note, that these
settings influence the internal reference level (0 dBint) you select in the Level Adjust column. If you change the
headroom of an 52-5230 or 52-5250 module and use the function Set all analog level afterwards, may be some