Teo IPTelephone Network - Manual (Page 46)

Teo IP Telephone Network Administration Guide
Page 46 13-280132 Rev. Q
General Phone Settings
XML Tag Data / Description
<phone_dial_timeout>
seconds
phone_dial_timeout>
When off-hook, this is the amount of time the phone
waits after a digit is pressed before sending the dialed
digits to the SIP Call Server for call processing, if the
user does not otherwise initiate sending by pressing
the SEND key.
A value of 0 (zero) allows an unlimited time for
dialing, with no timeout.
0 – 30 seconds, default value = 10
<sip_invite_timeout>
seconds
sip_invite_timeout>
This is the time period that the phone will wait for a
response to an INVITE when originating a call. The
call will be abandoned if the called party is not
detected before the timeout expires.
A value of 0 (zero) allows an unlimited time for the
server to respond, with no timeout.
0 – 120 seconds, default value = 40
<refer_timeout>
seconds
refer_timeout
Timeout for call transfers. If the transfer is not
completed by this time, the phone clears the calls.
0 – 99, default value = 4
<phone_max_ringing>
seconds
phone_max_ringing>
Specifies the maximum number of seconds that the
phone will persist in the ringing state for an incoming
call.
A value of 0 (zero) allows unlimited ringing, with no
timeout.
0 – 300 seconds, default value = 0
<phone_max_reorder>
seconds
phone_max_reorder>
Specifies the maximum number of seconds that the
phone will persist in the reorder (disconnected or
error) state.
A value of 0 (zero) allows the phone to stay in the
reorder state forever, with no timeout.
0 – 300 seconds, default value = 180
<ring_offhk_continuous>
ON/OFF
ring_offhk_continuous>
Determines whether the phone rings normally, or
only provides a single burst of ringing when the user
is on a call.
ON – continuous ring when off-hook
OFF – single ring when off-hook (default)