Teo IPTelephone Network - Manual (Page 13)

Network Setup
13-280132 Rev. Q Page 13
DHCP Option 125
Parameter Data / Description
UpdateSrvr Update server protocol, IP address or fully qualified
domain name, and port number. This configures the
same parameter as XML tag .
Refer to the DHCP Option 66 table (page 9) for allowed
values.
NOTE: To avoid conflicts, do not enter update server
parameters in DHCP Option 66 if it is set here.
ConfigFile The naming scheme for custom XML configuration
files (not used with the Teo protocol). This configures
the same parameter as XML tag
.
MAC – Ethernet MAC address (default)
LINE – phone line ID
L2Q Enables VLAN / Ethernet Layer 2 802.1Q support. This
configures the same parameter as XML tags
.
1 – VLAN enabled
0 – VLAN disabled (default)
NOTE: To avoid conflicts, do not enter VLAN data in
DHCP Option 242 if it is set here.
L2QVLAN
Phone VLAN ID.
A value of 0 (zero) indicates that the phone does not
belong to any VLAN; in this case, the 802.1Q tag
specifies only a priority and is referred to as a priority
tag. This configures the same parameter as XML tags
.
0, 2 – 4094, default value = 1111
NOTE: To avoid conflicts, do not enter VLAN data in
DHCP Option 242 if it is set here.
VoicePri 802.1Q Voice Priority Code Point. This configures the
same parameter as XML tags .
0 – 7, default value = 6
SignalPri 802.1Q Signaling Priority Code Point. This configures
the same parameter as XML tags .
0 – 7, default value = 6