Teletronics IP-PBX Server - Manual (Page 57)

57
4.3 Call Features
4.3.1 Authentication
When EZLoop® IP-PBX Enterprise SIP Server gets a Registration or Invite (incoming
call) from a remote location, it will reply Authentication for security issue.
4.3.2 Automated Attendant
The EZLoop® IP-PBX Enterprise SIP Server supports Automated Attendant; you can
record the default greeting and the other announcements by Extension. For more
information, please refer to
4.1.3 How to record the other announcements.
4.3.3 Call Transfer
The EZLoop® IP-PBX Enterprise SIP Server supports “server transfer” now; you can
enable the Hot-key Tran function in IP PBX and Trunk page. After enable Hot-key Tran,
you can press *9 for Call Transfer. You can also perform the Client based Call transfer by
subscriber device and the transfer function of the subscriber device should follow SIP
standard.
4.3.4 Blind Transfer (Client based)
The EZLoop® IP-PBX Enterprise SIP Server supports “server blind transfer” now; you
can enable the Hot-key Tran function in IP PBX and Trunk page. After enable Hot-key
Tran, you can press *0 for Blind Transfer. You can also perform the Client based Call
transfer by subscriber device and the transfer function of the subscriber device should
follow SIP standard.
4.3.5 Call Forward on Busy (Client based)
The EZLoop® IP-PBX Enterprise SIP Server does not support “server forward” now,
this feature should be done by client. For example, if the client is LP388, you can enable
this feature by LCD or “WEB” interface.
4.3.6 Call Forward on No Answer (Client based)
The EZLoop® IP-PBX Enterprise SIP Server does not support “server forward” now,
this feature should be done by client. For example, if the client is LP388, you can enable
this feature by LCD or “WEB” interface.
4.3.7 Call Forward Unconditional (Client based)
The EZLoop® IP-PBX Enterprise SIP Server does not support “server forward” now,
this feature should be done by client. For example, if the client is LP388, you can enable
this feature by LCD or “WEB” interface.
4.3.8 Call Hold/Retrieval (Client based)
Normally, the call hold and call retrieval is done by Client, the EZLoop® IP-PBX
Enterprise SIP Server just relay the SIP signal for such function.
4.3.9 Call Routing
In the Configuration  Routing Table, you can set the Routing record for a specified
Prefix.