Teletronics WLAN Inter-Building AP XI-1500 - Manual (Page 2)

Sep./24
th
/2000 2
n Insert the stand into the side slot of the Inter-Building Access Point, figured as below:
n Connect the Wireless Inter-building Access Point to a hub/station with a UTP
Ethernet cable . When connecting the Access Point to a PC, please use a cross-over
RJ-45 cable.
n Connect the power adapter to the power socket on the Access Point , and plug the
other end of the power pack into an electrical outlet.
NOTE: Use ONLY the power adapter supplied with the Wireless Inter-building Access
Point. Otherwise, the product may be damaged.
NOTE: The button, labeled “DEFAULT ” on the back panel of the Access Point, enables
you to retrieve the Access Point’s default setting. This is used when you forget the
password. Please detach the DC power plug and press the “DEFAULT” button on the
back panel of the Access Point. Reconnect the power and keep holding the button in for a
few seconds until the “AP” LED indicator blinks. This will start the Access Point with
default settings and enable you to configure the Access Point via utility, telnet or Web
again.
MDI
LINK
10/100
DEFAULT ANT. A
DC 12V