Teletronics TBC-800 - Manual (Page 4)

LEAF
CLASS
USING ROOT CONFIGURATION PAGE TO SETUP ROOT CLASS AND DEFAULT RATE.
USING PRIMARY GROUP PAGE TO DEFINE GROUP CLASS.
USING QoS SETTING PAGE TO DEFINE LEAF CLASS.
LEAF
CLASS
LEAF
CLASS
LEAF
CLASS
LEAF
CLASS
DEFAULT RATE
LEAF
CLASS
GROUP
CLASS 2
ROOT CLASS
GROUP
CLASS 1
LEAF
CLASS
LEAF
CLASS
Structure of Bandwidth Control
Figure 1
Installation
TBC should be installed between end users and router/ gateway to optimize the
performance and efficiency. This product is a hardware version, so it can be installed on
any traffic you would like to shape. Because TBC is in Bridge Mode, it can shape
bandwidth between different Subnet/IP as well.
TBC has one WAN port, and three LAN port. WAN interface should connect to
router/gateway of DSL, T1, or any internet connection. LAN interface should be
connecting to internal network directly or through a switch/hub.
Step s:
Set your computer 's IP Address to 192.168.1.100 with Subnet Mask: 255.255.255.0 (or
any available IP address in the 192.168.1.x subnet). Use a crossover cable to connect the
LAN1 port to your computer's Ethernet port. Connect power adapter to TBC-800.
For more information about configuration and operation, please see Web Configuration
Interface section. Please see the
next page for Installation Diagram (Figure 2).
4