Tech Source Raptor DL-Lite Drivers for Linux - Manual (Page 26)

Raptor DL-Lite Drivers for Linux Installation & Reference Manual
4-6
Modes "2560x1600"
EndSubSection
EndSection
# TSI Raptor DL-LITE XFree86 Configuration Sections
4.6 Selecting Bit-Depths
4.6.1 Setting Bit-Depths
The DL-Lite card supports 8-bit, 24-bit, 8+24-bit, 8+8, mox16,
mox24 and mox32 modes. By default these cards start up in 8-
bit mode.
These modes can be selected by modifying the
Device
section
and
Screen
section of the
XF86Config
file appropriately.
To set the bit-depth to 8-bit, the
"Mode"
option in the
Device
section needs to be set to 8 and the other values should remain
unchanged.
To set the bit-depth to 24, the
"Mode"
option needs to be set to
"24"
as shown:
Section "Device"
Identifier
"Raptordlt0"
Driver "rapdlt"
Card "TSI Raptor DL-LITE card"
BusID "PCI:0:12:0"
Option "Device" "/dev/rapdlt0"
Option "Mode" "24"
Option "ScaleCursPos" "on"
EndSection
To select the 8+24-bit mode, the
"Mode"
option should be set to
8+24
as shown in the following example. In this case the default
visual is 8-bit
PsuedoColor
.
Section "Device"
Identifier
"Raptordlt0"
Driver "rapdlt"
Card "TSI Raptor DL-LITE card"
BusID "PCI:0:12:0"
Option "Device" "/dev/rapdlt0"
Option "Mode" "8+24"
Option "ScaleCursPos" "on"
EndSection