Tech Source Raptor DL-Lite Drivers for Linux - Manual (Page 16)

Raptor DL-Lite Drivers for Linux Installation & Reference Manual
3-6
3.6.1 Monitor Section
This section for Raptor cards should remain unchanged.
3.6.2 Device Section
Identifier: Each Raptor card instance should have a
unique identifier. This identifer is used in the
Screen section.
NOTE: The BusID value in the configuration file must be
changed manually. Please see the description below for details.
BusID:
Depending on the machine and the slot the
card is in, it might receive a unique
BusID
.
When the driver attaches, it will print out the
device name and
BusID.
To check the
BusID
, type
dmesg|grep rap.
The
output should look similar to the following:
TSI: rapdlt0 (BusID 0:9:0) is
Raptor DL-LITE @ 2560x1600
In the example above, the Raptor DL-Lite
has a BusID of
PCI:0:9:0
. Change the
BusIDs of the cards in the XF86Config file
to match the BusIDs reported by the
drivers.
Option "Device": This field specifies the device name of the
Raptor card. The first Raptor card seen by
the system will be
/dev/rapdlt0
and the
second will be
/dev/rapdlt1
and so on.
The device name and the
BusID
specified
earlier in this section must correspond to the
same card.
Option "Mode": This field specifies pixel modes. It can be
one of the following.