Tech Source Raptor DL-Lite Drivers for Linux User Manual
Page 18

Raptor DL-Lite Drivers for Linux Installation & Reference Manual
3-8
3.6.3 Screen Section
Identifier:
Each screen must have a unique identifier
which will be used in the
ServerLayout
section.
Device:
This field specifies which device you want to
use for this screen. It should match the
Identifier specified in one of the
Device
sections.
DefaultDepth:
Should be set to either
8
or
24
depending
on the default visual desired. This is used
when 24-bit visuals will be used on the
screen, otherwise this field should be set to
8
.
Modes:
This field should remain unchanged.
If multiple Raptor cards are installed, additional
Screen
sections should be created. Each
Screen
section should
have a unique identifier. For more information please refer to
Section 4.5.
3.6.4 ServerLayout Section
This is the section which specifies the server layout for either
single-screen or multi-screen configuration.
This section is not modified automatically by the installation. It
must be modified for your specific configuration.
The following example shows the
ServerLayout
Section for a
single-screen configuration on the Raptor device.
Section "ServerLayout"
Identifier "XFree86 Configured"
NOTE: The ServerLayout section should already exist in
your
XF86Config
file. It must be modified manually to
include the Raptor card.