Tecfluid MX4 For FLOMID Series - Manual (Page 45)

45
13.2 Port connection
In the "Port" section, choose the appropriate port for the converter. This will appear with the
name of the port followed by MX4 and its serial number. Then click "Open".
Once the port is open, the button "Open" in the "Installation" and “Programming” sections
activates.
The USB connector is located below the right terminal strip (see figure on the previous
page).
Connect the USB cable at one end to the converter and at the other to the computer where
the software is installed.
Power on the electronic converter.
Execute the program WinsmeterMX4 following the sequence Start – Programs – Tecfluid
S.A. - WinsmeterMX4.
13
ASSOCIATED SOFTWARE WINSMETER MX4