Tecfluid MX4 For FLOMID Series - Manual (Page 15)

15
MX4 CONVERTER
1 INTRODUCTION
The MX4 converter unit can be used with the different FLOMID and FLOMAT series of
electromagnetic flow sensors. The electronic circuit is based on the most advanced
technology in digital signal processing, in order to obtain accurate and reliable
measurements.
The device provides the following features:
 Coil excitation by means of pulsed signal to obtain a negligible zero offset.
 Pulse and current output proportional to the flow rate and user programmable.
 Relay outputs user programmable as flow rate alarm or status.
 Local and remote mounting.
 Easy exchange with other sensors.
 Graphic display with intuitive menus.
 Adjustable front cover in order to make display reading easier, depending on
installation.
2 INSTALLATION
2.1 Sensor connection
2.1.1 Compact converter
The converter provides two
cables to be connected to the
sensor. Once connected,
slide the converter along the
sensor neck until the stop.
Tight the two fixing screws.
INTRODUCTION
1