Tascam MMR-8 - Manual (Page 146)

TASCAM MMR-8 Owner’s Manual • Appendix D • Cable Information 146
TIMECODE IN Connector
PIN # Signal Description
TIP Time Code Reader +
Ring Time Code Reader -
Sleeve Ground
NOTES:
1. 1/4” TRS Phonejack
2. 10K Ohm input impedance. Differential input.
TIMECODE OUT Connector
PIN # Signal Description
TIP Time Code Reader +
Ring Time Code Reader -
Sleeve Ground
NOTES:
1. 1/4” TRS Phonejack
2. Differential op-amp output circuit.
WORD CLOCK IN Connector
NOTES:
1. BNC, 75 Ohm Terminated. TTL logic levels.
WORD CLOCK OUT Connector
NOTES:
1. BNC, 75 Ohm Drive Capability. TTL logic levels.
VIDEO IN/OUT Connector
NOTES:
1. BNC, Video is connected in parallel between connectors.
2. 1K Ohm input impedance. Supports Composite, Color Bars, Black Burst.
Should be 75 ohm terminated if at end of cable.