Tascam MMR-8 - Manual (Page 145)

TASCAM MMR-8 Owner’s Manual • Appendix D • Cable Information 145
DIO (AES/EBU Digital Audio) Connector pinout
PIN # Signal Description PIN # Signal Description
1 Digital Output 4 (ch 7&8) + signal 14 Digital Output 4 (ch 7&8) - signal
2 Digital Output 4 (ch 7&8) ground 15 Digital Output 3 (ch 5&6) + signal
3 Digital Output 3 (ch 5&6) - signal 16 Digital Output 3 (ch 5&6) ground
4 Digital Output 2 (ch 3&4) + signal 17 Digital Output 2 (ch 3&4) - signal
5 Digital Output 2 (ch 3&4) ground 18 Digital Output 1 (ch 1&2) + signal
6 Digital Output 1 (ch 1&2) - signal 19 Digital Output 1 (ch 1&2) ground
7 Digital Input 4 (ch 7&8) + signal 20 Digital Input 4 (ch 7&8) - signal
8 Digital Input 4 (ch 7&8) ground 21 Digital Input 3 (ch 5&6) + signal
9 Digital Input 3 (ch 5&6) - signal 22 Digital Input 3 (ch 5&6) ground
10 Digital Input 2 (ch 3&4) + signal 23 Digital Input 2 (ch 3&4) - signal
11 Digital Input 2 (ch 3&4) ground 24 Digital Input 1 (ch 1&2) + signal
12 Digital Input 1 (ch 1&2) - signal 25 Digital Input 1 (ch 1&2) ground
13 No connection
NOTES: 25-pin D-subminiature female connector (DB-25).
SYNC (MMR-Bus) Connector pinout
PIN # Signal Description PIN # Signal Description
1 CAN_BUS+ 9 CAN_BUS-
2 CCLK_BUS0+ 10 CCLK_BUS0-
3 CCLK_BUS1+ 11 CCLK_BUS1-
4 CCLK_BUS2+ 12 CCLK_BUS2-
5 CCLK_BUS3+ 13 CCLK_BUS3-
6 +12 TERM PWR 14 Frame ground
7 CAN LEFT TERM 15 CAN RIGHT TERM
8 N/C
NOTES:
1. 15-pin D-subminiature female connector (DB-15). The two connectors are
paralleled in the MMR-8 and either can be used as an input or output.
2. TASCAM supplies a 3 foot interface cable, 70447. The differential signals
should be routed on twisted pairs of wires.