Teac CD-200SB - Manual (Page 18)

18
TASCAM CD-200SB
3 – Preparations
Inserting and removing SD cards
Inserting SD cards
To use an SD card with this unit for playback/dubbing, insert the
SD card into the SD card slot on the front panel.
NOTE
You can insert an SD card regardless of whether the power is ON
or OFF.
1. Pull the SD card slot cover forward to open it.
2. Insert the SD card with the correct orientation.
The label side should be up and the connector end should
be inserted first.
3. Close the card slot cover.
NOTE
If the SD card slot cover will not close, remove the SD card once
and then reinsert it.
Removing SD cards
Turn the power OFF or stop operation before removing an SD
card.
CAUTION
Never remove an SD card when this unit is operating (playing
back, writing data to the SD card, etc.). Doing so could, for
example, cause dubbing to fail, data to be lost or sudden loud
noises from monitoring equipment, which might damage the
equipment or harm your hearing.
1. Pull the SD card slot cover forward to open it.
2. Press the SD card in gently to make it eject partially.
3. Grasp the SD card and pull it out.
SD card write-protection switches
SD cards usually have write-protection switches.
Writing possible Write-protected
When the write-protection switch is shifted to the “LOCK”
position, dubbing and folder erase operations are not possible.
To use the dubbing (copying) and folder erase functions, make
sure write-protection is unlocked.
This unit saves direct folder settings on SD cards. These settings
cannot be written to an SD card that has its write-protection
switch set to LOCK. If the SD card is locked, these settings will be
lost when the media is removed and the power is turned OFF.
(See “Saving direct folder settings” on page 32.)