Teac CD-200SB - Manual (Page 17)

TASCAM CD-200SB
17
3 – Preparations
Preparing the remote control
Inserting batteries
1. Open the lid.
2. Confirm +/- polarity, and insert two AA batteries.
3. Close the lid.
Replacing the batteries
Replace both batteries with new ones when the range of
the remote control becomes short or if the function buttons
become unresponsive.
Cautions about the use of batteries
Misuse of batteries could cause them to leak, rupture
or otherwise be damaged. Please read and abide by the
precautions on them when using batteries. Also see “CAUTIONS
ABOUT BATTERIES” on page 4.
Cautions about using the remote control
• When using other devices controlled by infrared rays, use of
this remote control might operate these devices by mistake.
• Use the remote control within the following range.
Remote Sensor
Operation distance
Directly in front: Within 7 meters
15° left or right: Within 7 meters
Loading a CD
To load a CD, press the OPEN/CLOSE button on the main unit or
on the remote control to open the disc tray, and put the CD into
the tray with the label facing up.
Press the OPEN/CLOSE button again to close the disc tray. After
loading the disc, the unit reads the disc’s information and the
display shows the total number of tracks and total playback time
if it is an audio CD or the total number of tracks in the current
folder or on the entire disc if it is a data CD.
NOTE
• When the current media is set to CD, instead of pressing the
OPEN/CLOSE button to close the disc tray, you can press
the PLAY/PAUSE button to close the disc tray and begin
playback immediately.
• If you open the disc tray while this unit is in use, the
following settings are lost.
– Program
– Current folder (for data CDs)