Teac CR-H260I - Manual (Page 19)

19
ENGLISH
A
MULTI JOG knob
In CD/USB/SD mode, use this knob to skip to the pre-
vious or next track or file (page 33).
In iPod mode, use this knob to scroll up and down the
menu.
In TUNER modes, use this knob to tune to stations or
select preset stations (page 38).
After pressing the TONE/BAL button, turn this knob to
adjust bass, treble and balance (page 24).
B
Remote control signal receiver
When using the remote control, point it toward this
receiver panel.
C
Display
D
VOLUME knob
Use this knob to adjust the volume.
E
Disc tray
F
STANDBY/ON indicator
The standby indicator lights orange when in standby
and turns off when the unit is on.
G
STANDBY/ON button
Press this button to turn the unit on or put it in standby
mode.
p If there is no playback signal from the selected input
source and this unit is not operated for 30 minutes,
this unit will enter standby mode (page 23).
H
PHONES jack
Connect headphones with a standard 3.5 mm (1/8")
stereo plug here.
p In iPod mode, no sound is output from the PHONES
jack.
I
USB port
Connect an iPod/iPhone/iPad or USB flash drive here.
J
SD memory card slot
Insert an SD memory card here.
K
SOURCE button
Use this button to select the source.
L
TONE/BAL button
Use this button with the MULTI JOG knob to adjust
bass, treble and balance.
M
MENU/FM MODE button
In iPod mode, use this button to go back to the previ-
ous menu.
In TUNER FM mode, use this button to select stereo or
mono.
N
STOP [8], RDS (For Europe)
STOP [8] (For North America)
In CD/USB/SD mode, use this button to stop playback.
In TUNER FM mode, use this button to select an RDS
mode. (Only for Europe)
To enter Bluetooth pairing mode, press and hold this
button for at least 2 seconds.
O
Play/Pause [7/9]
In CD/USB/SD/iPod mode, use this button to start or
pause playback.
P
Open/Close [- ], TUNING MODE/ENTER
button
In CD mode, use this button to open and close the
disc tray.
In iPod mode, use this button to confirm selections in
menus.
In TUNER mode, use this button to select the tuning
mode (page 38).
While setting the timer or the clock, use this button to
confirm the setting.