Sundance SMT118 - Manual (Page 7)

Version 1.0 Page 7 of 20 SMT118v2 User Manual
additional electronic circuitry associated with these signals, so they could be used for
any general purpose requirement.
Comm-ports
Full Comm-port connectivity is provided using the following scheme:
With this method, a dual pipe exists between the modules in a 0-3 and 1-4 routing
fashion. Taking the global bus issues into consideration, three CPU TIMs could be
mounted on the SMT118 and good Comm-port communications established.
No active or passive electronic circuitry is connected to these Comm-ports but in
normal operating conditions no signal is left un-driven for any length of time.
Reset
As the SMT118 is intended for stand-alone operation, then the system reset must be
provided locally. This is implemented by a device which monitors the 5V power line
and generates a system reset to all TIM sites and on-board peripherals for
approximately ½ second after the power line is stable.
In addition to this reset mechanism there is a reset push-button switch provided, and
the shorting of the reset pin to ground (see CONN8 in connector section) will also
cause a ½ second reset.