Studio Technologies 50 2004 - Manual (Page 22)

Issue 6, September 2004 Model 50/51 User Guide
Page 22 Studio Technologies, Inc.
Model 51 Configuration Chart—Main Functions
Press a Communications
button to toggle between
latching or momentary
operation; LED on means
the button is set to latch
Press CR/Studio 1 through
7 to toggle each channel’s
input sensitivity between
–10dBV and +4dBu; LED on
means input is set to +4dBu
Press and hold Dub,
then press CR/Studio 1
to toggle the dub output
between –10dBV and
+4dBu; LED on means
dub is set to +4dBu
Press and hold Phones/Studio,
then press CR/Studio 1 through 7
to toggle the inputs between stereo
and mono operation; LED on
means input is set to mono
Press and hold Dub, then press
CR/Studio 2 through 7 to select a dim level:
LED 2 is Max. attenuation (approx. 72dB)
LED 3 is 30dB
LED 4 is 25dB
LED 5 is 20dB
LED 6 is 15dB
LED 7 is 10dB
Press Mono to toggle
between latching or
momentary operation;
LED on means the
Mono button is set
to latch
Press Dim to toggle
the automatic dim off
function; LED on means
auto dim off function
is active
Press and hold Level
Up to activate alternate
configure functions
(refer to next page)
Press
and hold
Dub and
Phone/Studio
for 2 seconds
to reset all
parameters
to factory
defaults
Press button to toggle between
studio follows control room
source and studio follows head-
phone source; LED on means
studio follows headphones
Press and hold
Configure for two seconds
to enter or exit the configure
mode; while in configure,
LED will flash