SOMFY CORD LIFT WIREFREE CL32 RTS - Manual (Page 2)

3 Copyright © 2013 Somfy SAS. All rights reserved - V1 - 02/2013
CONTENTS
1. Introduction2
2. Safety2
2.1. Safety and responsibility2
6SHFL¿FVDIHW\DGYLFH3
3. Installation 3
3.1. Motor preparation3
3.2. Tube preparation3
3.3. Motor/tube assembly3
3.4. Mounting the motorized tube on the
brackets3
4. Wiring4
5. Commissioning 4
5.1. Programming the RTS transmitter4
5.2. Checking the rotation direction4
5.3. Adjusting the end limits4
5.4. Recording the RTS transmitter5
5.5. Favorite position:
MY position / Recording MY
position.5
6. Operation5
6.1. Mode selection: Roller or Tilting
mode5
6.2. Up, Down, My: In roller mode5
6.3. Up, Down, My: In tilting mode6
7. Additional setting6
7.1. Favorite position: MY position6
7.2. End limit re-adjustement7
7.3. Adjusting the tilting speed7
7.4. Modifying the motor rotation
direction7
7.5. Modifying the wheel rotation
direction 8
7.6. Adding/Deleting RTS transmitter 8
7.7. Erasing the transmitters from the
memory 8
7.8. Erasing the memory of the motor8
8. Troubleshooting9
9. Technical data9
1. INTRODUCTION
The Cord lift 32 RTS is a motor specially dedicated to interior applications.
The Cord lift 32 RTS can motorize roman, pleated and cellular shades.
The Cord lift 32 RTS is a battery operated motor, powered with lithium primary bat-
teries or NiMH batteries with solar pack. The motor can also be powered by a power
supply.
Warning : The Cord lift 32 RTS is compatible only with the «Sunis Indoor WireFree
RTS» sensor.
Warning : The Cord lift 32 RTS cannot be used with sealed double glazing.