SOMFY OREA - Manual (Page 4)

3) Readjusting of the DOWN limit after the transmitter has been programmed.
a) Modify the DOWN or awning extended limit first. Using the transmitter bring the product to the DOWN limit.
The motor must reach the DOWN limit and stop on its own.
b) Follow the steps below.
c) Adjust the DOWN limit to the new position (the motor will respond to the transmitter in a momentary fashion).
d) Record the new DOWN limit.
e) The new DOWN or extended limit has been recorded.
5 Seconds
>2 Seconds
Press for more than 5 Seconds
on the UP button and the DOWN
button simultaneously
Release after the awning jogs briefly UP/DOWN
indicating that the change has been memorized
in the motor.
Press the STOP button
for more than 2 seconds
Release the buttons after the end-product jogs briefly
UP/DOWN indicating that the motor is in the
"END LIMIT SETTING STATE".
Release it when the end-product jogs briefly
UP/DOWN indicating that the transmitter has
been memorized into the motor
Press the programming button
on the RTS transmitter
1) Provide power to the OREA RTS motor. Press UP, STOP or DOWN on any transmitter in order to take
control of the motor (Do not press UP and DOWN simultaneously because this will delete the limits). Check that the OREA RTS
motor is in INSTALLER MODE. In this mode the OREA RTS motor runs when a directional button on the transmitter is pressed
and held (momentary fashion), and the OREA RTS will stop at its preset end limits.
NOTE:
2) Recording the first Transmitter or Channel. On 4 channel transmitters select the desired channel before pressing the
programming button.
independently
If you do Press the UP & DOWN transmitter buttons simultaneously after a single power cut, then you will lose the confirmed
limits and enter FACTORY MODE with this new transmitter/channel already activated.