Smithy Midas 1220 XL - Manual (Page 12)

Chapter 2
Safety
Your workshop is only as safe as you make it. Take responsibility for the safety of all who
use or visit it. This list of rules is by no means complete, and remembers that common
sense is a must.
1.
Know your machine. Read this manual thoroughly before attempting to operate your
lathe-mill-drill. Don't try to do more than you or your machine can handle. Understand
the hazards of operating a machine tool. In particular, remember never to change speeds
or setups until the machine is completely stopped, and never to operate it without first
rolling up your sleeves or tying them at your wrists.
2.
Ground the machine. The Midas 1220 XL has a three conductor cord and a three
pronged grounding type receptacle. Never connect the power supply without properly
grounding the machine.
3.
Remove all adjusting keys and wrenches from the machine before operating. A chuck
key or misplaced Allen wrench can be a safety hazard.
4.
Keep your work area clean and organized. Cluttered work areas and benches invite
accidents. Have a place for everything and put everything in its place.
5.
Keep children away from the machine while it is in use. Childproof your shop with
padlocks, master switches, and starter keys, or store the machine where children do not
have access to it.
6.
Wear appropriate clothing. Avoid loose fitting clothes, gloves, neckties, or jewellery
that could get caught in moving parts. If you have long hair, tie it up or otherwise keep
it out of the machine.
7.
Use safety glasses, goggles, or a face shield at all times. Use glasses designed for
machinery operation; regular glasses will not do. Have extras for visitors. Know when to
wear a face mask and earplugs, as well.
8.
Check for damaged parts. Make sure the machine will run properly before operating it.
9.
Disconnect the machine before servicing and when changing accessories. Shut power
off before making changes, removing debris, or measuring your work. Don't reach over
the machine when it's operating. Keep you hands out of the way.
10.
Avoid accidental starts. Turn the switch to Off before plugging in the machine.
11.
Secure your work. Flying metal is dangerous. Loose work can also bind tools.
12.
Use the recommended accessories. Understand how to use them before trying them
out.
2-1
For Assistance: Call Toll Free 1-800-476-4849