Smithco Switch Pro Installation & Operation Manual - Manual (Page 15)

CHAPTER
3
Manual No. 016-0171-219 11
Chapter 3
Using the Switch Pro
System
Switch Pro Nodes
The Switch Pro built-in AccuBoom, boom/speed, and single product nodes are automatically recognized by the
Envizio Pro or Viper Pro field computer.
The built-in single product node will always be detected as product or control channel 1 on the field computer.
If additional product control nodes are connected to the system, make sure to re-address these nodes on the
Envizio Pro or Viper Pro field computer.
Refer to the Envizio Pro or Viper Pro Installation & Operation Manual for information on addressing the CAN
nodes connected to a CANbus system.
Note:
To ensure proper operation of the Switch Pro system, make sure the field computer has the latest
version of software. Switch Pro requires Viper Pro version 2.52 or higher or Envizio Pro version
1.00C or higher.
Refer to the field computer Installation & Operation Manual for more information on software
updates.
Using Switch Pro
Logic Power LED
The logic power LED displays the status of logic power. This LED is switched by the Envizio Pro or Viper Pro
power and illuminate green when logic power is On.