Smithco Switch Pro Installation & Operation Manual - Manual (Page 11)

Manual No. 016-0171-219 7
Installation
Switch Pro/Envizio Pro Mounting Bracket
The Switch Pro/Envizio Pro mounting bracket (P/N 107-0171-841) mounts the Switch Pro switch box below the
Envizio Pro field computer.
1. Match up mounting posts on the Envizio Pro with the pre-drilled holes in the mounting bracket and the
square flange on the RAM socket arm.
a. The mounting bracket should not interfere with any cable connections or ports on the Envizio Pro field
computer.
b. When assembled, the lower flange of the mounting bracket should be approximately centered below
the console and slightly forward of the upper flange.
Note:
When mounting the Switch Pro unit with a Viper Pro field computer, the optional Viper Pro
mounting bracket (P/N 115-0171-181) can be used to mount the Switch Pro either above or below
the field computer.
Optional RAM Mount components are also available for remote mounting of the Switch Pro unit.
See the Switch Pro Kit Contents section on page 2 for component part numbers for the remote
RAM mounting arm.
2. Use the supplied hardware to fasten the mounting bracket and RAM mounting arm to the Envizio Pro field
computer.
Interface Cable
Connections
Mounting Posts
Mounting Bracket